TS-11 Iskra model cockpit

Ten post dostępny jest także w języku: Polish

Project of TS-11 Iskra model slowly approaches the stage of preparation of 3D prints, the last parts of what I was doing are the inside of the cockpit, and details on the middle section of the fuselage. The challenge was to maintain the proportion of parts in the confrontation with the technology of resin casting (seat width, the width of the side panels and the thickness of the side walls.

After designing all the interior details remain just to design a few details that appear only on one side of the airframe, such as reflector for landing. We are preparing the master for vacu forming a canopy at now.
kabina TS-11 na tle reszty samolotu

iskra od spodu

tablica przyżadów Iskry

Iskra - boczek kabiny

drugi boczek kabiny Iskry /TS-11

Author: Marcin Ciepierski

Marcin jest profesjonalnym projektantem 3D. Przygodę z modelami zaczął w klubie "Śmigiełko" jako nastolatek. Skleja modele samolotów US Navy w skali 1:72. W firmie Arma Hobby jest wspólnikiem odpowiedzialnym za projektowanie modeli.

Share This Post On
468 ad

Submit a Comment

Your email address will not be published. Required fields are marked *